Sample Sidebar Module

This is a sample module published to the sidebar_top position, using the -sidebar module class suffix. There is also a sidebar_bottom position below the menu.

HOME

OXIDIZED BITUMEN

EMULSION

PENETRATION

CUTBACK

MODIFIED

BITUMEN GRADE

PETROLEUM

ABOUT US

CONTACT US

Sample Sidebar Module

This is a sample module published to the sidebar_bottom position, using the -sidebar module class suffix. There is also a sidebar_top position below the search.

Search Our Site

MC 3000




Cutback Asphalt MC 3000

Cutback bitumen MC 3000 is dissolved of bitumen in solvents of kerosene. In many countries kerosene and other volatile petroleum derived products are added as a cutter or cutback agent to bitumen to reduce (or cutback) the viscosity of the bitumen. The mixture obtained may be called cutback bitumen.The reduction in viscosity of the bitumen aids the construction of seal coats in road pavements as the softened mixture wets the chips more easily. The cutback agent evaporates from the seal coat, the cutback agent becoming a negligible component of the seal coat a few months after application. If significant amounts of the cutback agent remain in the seal coat an unwanted long term softening effect may result.


Application of cut back asphalt MC 3000:

Cutback bitumen MC-3000 consist of initial incorporation of asphalt into the surface of non-asphalt based course preparatory to any superimposed treatment of construction. Furthermore cutback asphalt MC-3000 mostly apply to waterproofing of surfaces, plug capillary voids, coat and bond loose mineral particles. Cutback agents also are used to lower the viscosity of bitumen when it is applied as a primer to the surface of a road pavement aggregate base course or substrate.
We use Kerosene as a bitumen cutback agent at different concentrations according to local conditions and requirements.
The cutback bitumen is ideal for prime coat and cold applied. This property is because of easy uses and no need to thinning and heating.


Packing of cutback bitumen MC 3000:
Packing of cutback bitumen MC 3000 is in new thick steel drum. This drums are on pallet to prevent any leak inside of container. Also bulk in bitutainer and tanker is possible.



Data Sheet Of Bitumen MC 3000:

Properties Min Max Test Method
 Kinemalic 1 viscosity at 60°C, ESt 3000 6000 ASTM D2170
 Flash Point (Tag Open-Cup),°C 66 - ASTM D1310
 Distillate test 2 :      
 Distillate, percent by Volume of total 360°C
 To 190°C - - ASTM D402
 To 225°C - - ASTM D402
 To 260°C - 15 ASTM D402
 To 316°C 80 - ASTM D402
 Residue from distillation to 360°C:
 Test on residue from distillation Penetration at  80 -  
  25°C,100 g, 5 sec.
 Ductility 3 at 25°C, cm 120 250 ASTM D402 / ASTM D113
 Solubility in trichloroethylene, percent mass 100 - ASTM D402 / ASTM D2024
 Water, percent volume - 0.2 ASTM D95





  • fr-FR
  • English (UK)
  • You are here:  
  • Home .
  • CUTBACK .
  • MEDIUM CURING .
  • Cutback Bitumen MC 3000