Sample Sidebar Module

This is a sample module published to the sidebar_top position, using the -sidebar module class suffix. There is also a sidebar_bottom position below the menu.
Login
Register

Sample Sidebar Module

This is a sample module published to the sidebar_bottom position, using the -sidebar module class suffix. There is also a sidebar_top position below the search.

Search Our Site

Register




cutback asphalt SC 70

Cutback bitumen SC 70 is dissolved of bitumen in solvents of kerosene. In many countries kerosene and other volatile petroleum derived products are added as a cutter or cutback agent to bitumen to reduce (or cutback) the viscosity of the bitumen. The mixture obtained may be called cutback bitumen.
The reduction in viscosity of the bitumen aids the construction of seal coats in road pavements as the softened mixture wets the chips more easily.
The cutback agent evaporates from the seal coat, the cutback agent becoming a negligible component of the seal coat a few months after application.
If significant amounts of the cutback agent remain in the seal coat an unwanted long term softening effect may result.

Application of cut back asphalt SC 70:

Cutback agents are used to lower the viscosity of bitumen when it is applied as a primer to the surface of a road pavement aggregate base course or substrate. Kerosene is used as a bitumen cutback agent at different concentrations according to local conditions and requirements.
The cutback bitumen is ideal for prime coat and cold applied because of easy uses and no need to thinning and heating.
Cutback bitumen SC 70 consist of initial incorporation of asphalt into the surface of non-asphalt based course preparatory to any superimposed treatment of construction.
The cutback asphalt SC 70 applying to waterproofing of surfaces, plug capillary voids, coat and bond loose mineral particles.


Packing of cutback bitumen SC 250:
Packing of cutback bitumen SC 250 is in new thick steel drum. This drums are on pallet to prevent any leak inside of container. Also bulk in bitutainer and tanker is possible.



Data Sheet Of SC 70:


Properties Min Max Test Method
 Kinemalic 1 viscosity at 60°C, eSt 70 140 ASTM D2170
 Flash Point (Tag Open-Cup),°C 65 - ASTM D1310
 Distillate test 2 :      
 Distillate, percent by Volume of total 360°C
 To 190°C - - ASTM D402
 To 225°C - - ASTM D402
 To 260°C - - ASTM D402
 To 316°C 10 30 ASTM D402
 Residue from distillation to 60°C:                      400        7000
Test on residue from distillation Penetration at  50 -  
  25°C,100g, 5 sec.
 Ductility 3 at 25°C, cm 100 - ASTM D402 / ASTM D113
Solubility in trichloroethylene, percent mass 100 - ASTM D402 / ASTM D2024
 Water, percent volume - 0.2 ASTM D95




  • fr-FR
  • English (UK)

CHEMICAL MINE WORLD LTD.

Unit level 14(B) & 14 (C) Main office tower, Financial Park Labuan Complex, 
Jalan Merdeka, Federal Territory of Labuan, 87000, Malaysia